fbpx
Seats Shown: Top: Phenolic white with slots for water drainage. Bottom: Naugahyde white cushion Seachrome Bench Style 28" x 15" Shower Seat Naugahyde White cushion SSB-280150 NW Image 3 Image 4 Save SEACHROME BENCH STYLE 28" X 15" SHOWER SEAT NAUGAHYDE WHITE CUSHION SSB-280150 NW $384.50 $298.75
SEACHROME COMMERCIAL DOUBLE ROLL SURFACE MOUNT PAPER HOLDER CHROME FINISH (QTY = 24) - SCM-R5580 $669.84 $502.38

SEACHROME BENCH STYLE 48″ X 24″ SHOWER SEAT SWING DOWN LEGS | SSB2-480240

In Stock

$899.00 $697.25

Compare

Seachrome Bench Style 48″ x 24″ Shower Seat  Swing Down Legs | SSB2-480240

STANDARD SEAT MATERIALS/COLORS
Naugahyde – White or Almond, covering 2” (51mm) thick foam mounted on 1/2” (13mm) thick marine plywood.

Phenolic – White or Teak, 1/2” (13mm) thick x 3” (76mm) wide slats bolted to frame with countersunk stainless steel screws.

Phenolic Solid – White or Teak, solid 1/2” thick single seat top with slots for drainage.

HDPE (High Density Polyethylene) – White, 1/2” thick one piece.

Solid Surface – Various Colors, 1/2” thick solid surface material.

SPECIFICATIONS
Seachrome seats meet Federal Spec. WW-P-541/8B and ANSI 117.1. When properly installed, all seats exceed applicable federal load specifications. These models have been independently tested to withstand 1,000 lbs in a 30-minute static load test.

 

Printable Specification Sheet

Seachrome SSB2-480240 – Spec Sheet

 

NOTE: Seachrome recommends that all accessibility seats, as well as grab bars, be installed using 2” minimum thickness “in-wall” solid wood backing material with #10 x 2” stainless steel, Phillips head, sheet metal screws, or using a wall-imbedded minimum 12 gauge (2.8mm) steel anchor plate with #10 x 24 stainless steel machine screws.

LOAD BEARING AND INSTALLATION:

When properly installed, all Seachrome shower seats have been designed and manufactured to support loads exceeding the downward pull requirements for Federal specifications FHA, VA, HUD, hospital codes, and private construction. The actual “in use” load bearing capacity of any shower seat, however, will be limited by the strength of its mounting surface and installation hardware. Seachrome recommends that shower seats be installed using 2″ minimum thickness “in wall” solid wood backing material with #10 x 2″ stainless steel, phillips-head, sheet metal screws, or using a wall embedded, minimum 12 ga. (2.8mm) steel anchor plate with #10 x 24 stainless steel machine screws. Please contact the factory for further mounting recommendations.
Under no circumstances should any shower seat be mounted to drywall, sheetrock, plaster, fiberglass, acrylic or other similar “hollow” wall surfaces without appropriate wood or steel backing material.

Reviews

There are no reviews yet.

Be the first to review “SEACHROME BENCH STYLE 48″ X 24″ SHOWER SEAT SWING DOWN LEGS | SSB2-480240”

Your email address will not be published. Required fields are marked *

Back to Top
Social media & sharing icons powered by UltimatelySocial